Routing Techniques

Tips for a proper, organized PCB

Good Routing Techniques

  • Do not route traces close to the edge. 
  • Do not place EMI-emitting components, such as crystals, near a board edge.
  • Surround pulsating traces with proper ground plane fill to reduce EMI.

Verticals and Horizontals

  • Use front and back for horizontal and vertical traces respectively, or something similar to avoid clashing.
  • Pick sides which do not force the abuse of vias for routing smd components.
  • Let busses take precedence over singular traces (explained below).

Trace Bus

  • Route many traces going in the same direction together for efficient use of space.
  • This can be used to efficiently break out many traces from the controller.


Revision #4
Created 25 January 2018 11:45:36 by ai03
Updated 29 June 2020 01:52:32 by ai03