Skip to main content
Routing Techniques
Tips for a proper, organized PCB
Good Routing Techniques
- Do not route traces close to the edge. This will create massive amounts of EMI.
- Do not place EMI-emitting components, such as crystals, near a board edge.
- Surround pulsating traces with proper ground plane fill to reduce EMI.
Verticals and Horizontals
- Do not route both verticals and horizontals on the same layer unless necessary.
- Route horizontals on back, verticals on front, etc.
- Pick sides which do not force the abuse of vias for routing smd components.
Trace Bus
- Route many traces going in the same direction together for efficient use of space.
- This can be used to efficiently break out many traces from the controller.
